Sliding Gate Valve (Old Version)
Sliding Gate Valves
Easily shut off downpipe water flow and control the movement of water with the versatile Rain Harvesting Sliding Gate Valve.
New versions now available:
90mm Sliding Gate Valve (Plastic Paddle)
90mm Sliding Gate Valve (Stainless Steel Paddle)
New versions now available:
90mm Sliding Gate Valve (Plastic Paddle)
90mm Sliding Gate Valve (Stainless Steel Paddle)
Size 90mm
HW0900
There are new versions of the Sliding Gave Valve now available:
90mm Sliding Gate Valve (Plastic Paddle)
90mm Sliding Gate Valve (Stainless Steel Paddle)
If you have any questions about the old or new sliding gate valves, please use our contact us page to get in touch.
Features
Suitable for low pressure applications (pressure rated to 210kPa)
Can be used as a fire safety device to keep water where you need it
Manufactured from UV stabilised uPVC and chemical resistant polypropylene with stainless steel nuts and bolts
Can be used as a wet system drain valve on rain harvesting systems
Simple, hand-operated sliding gate shuts off water flow
90mm female fit
-
Specifications
-
Installation
- Select your desired installation point. The Sliding Gate Valve can be installed in the vertical and horizontal position.
- Measure and remove a 24mm section of pipe at your desired installation point. Ensure all cut edges are clean and smooth.
- Use priming fluid to clean inside the sockets of the Sliding Gate Valve and outside of the pipes you will be gluing the valve to.
- Apply solvent weld glue first to inside the sockets of the Sliding Gate Valve and then to the outside of the pipes, bring together and ensure pipes are inserted fully into the sockets of the Sliding Gate Valve. Hold for a minimum of 60 seconds or until secure.
-
What's in the box?
- Sliding Gate Valve
-
Tools you might need
- Marker pen
- Tape measure
- Saw
- Solvent weld glue
- Priming fluid
